L298N Dual H Bridge DC Stepper Motor Drive Controller Module

  • Shipping Weight: 30g
  • 996 Units in Stock
Qty :






1.Using L298N made by ST company as the controller

2. Built-in 78M05. An external 5V logic supply when using more than 12V driving voltage is needed.

3.Using large capacity filter capacitor, and protect diodes. Improved reliability



L298N is a high voltage, high current motor driver chip produced by ST. Having 15 pins as package, this chip has such features as high working voltage (maximum voltage up to 46V), large output current (peak current up to 3A, rated current 2A) and 25W rated power. Two built-in H bridge drivers can be used to drive the DC motor and stepper motor, relay coil and so on. Using standard logic level signal control, it has two enable control input, which starts or stop the device. So that the internal logic circuit part works at low voltage. The chip can connects to external detecting resistor to give the variations to the control circuit. L298N can drive a stepping motor or four phase stepping motor, and two DC motors as well.



Driving Step motor



Driving DC motor




43 mm / 43 mm



Customized Design & Technical Support


If you have technical questions or customized design requirement,

please contact us to get support from our engineers team.

You may send your information to Email: brickelectric@hotmail.com


Current Reviews: 3