1.High quality charging Chip TP4056, simple circuit, good protective value, high
2.Complete mechanical automation processing, High reliability.
3.Automaticlly adjust the output current from 100 to 1000ma by simply changing
the fixed resistor on the circuit board.
It can be used to charge for one pcs of lithium battery or serval parallel
Input Voltage: 4.5~5.5V
Full charging voltage: 4.2V
Max output current:1A
Power Indicator: Red stands for charging, Green stands for fullly charged.
Input interface: Micro interface
Item Size: 25mm*19mm.
3.The output current and the corresponding resistance
R1 K I(mA)
1.The Ampere meter can only be connected to 5v input port of the module.
2.It is better that the charging current is 37% of the battery capacity. For
example, the charging current should be 400 for the 1000mAH battery.
3.The connection wire should not be too thick.
4.Make sure the connect point is good.
5.If the input voltage is too high, For example 5.2V or even 5.5V, then the
charging current will be less than 1000mA, it is normal. When the voltage is too
high, the chip will automatically reduce the charging current to protect the
chip from burnning damage. Besides, it is normal that the chip feel hot when the
working temperature of the chip is around 60
you have technical questions or customized design requirement,
please contact us to get support from our engineers team.
may send your information to Email: firstname.lastname@example.org